Início > Notícia > Notícia

How to Choose the Right V-Belt For Agricultural Machinery?

May 19, 2021

The following V-Belt Suppliers tell you how to choose the right V-belt

The selected model should match with the selected V-belt, otherwise the V-belt will be abnormal in the pulley groove. When changing V-belt, it is better to bring the old V-belt to the agricultural machinery department for purchase. The model number is not correct.

Before correct installation, if the center distance of the two axes can be adjusted, the center distance should be shortened, and then adjust the center distance as required after the belt is installed; if the center distance of the two axes cannot be adjusted, a triangle First put the belt into the pulley groove, then turn the other pulley to install the V-belt, and install all V-belts in the same way. It is strictly forbidden to pry or pull the V-belt with tools to prevent the V-belt from being stretched or too loose or too tight.

V-Belt

V-Belt

To prevent the pulleys from being installed in series, the centers of the two pulleys above must be aligned, otherwise the V-belt will work unilaterally, causing serious wear and reducing the service life of the V-belt.

The tightness of the V-belt must be checked and adjusted frequently to make it meet the requirements. A too loose V-belt is not only easy to slip, but also will increase the wear of the V-belt and even fail to transmit power. Too tight will not only make the v-belt elongated deformation, easy to damage, and will make the engine main bearing clutch bearing due to excessive force and damage. And accelerate the wear of the V-belt. The correct way to check is to apply about 2 kg of vertical pressure in the middle of each belt by hand, the amount of sinking is appropriate, and should be adjusted in time when it is not suitable.

When it is necessary to replace the old and new mixed double belts or more than three Agricultural Belts, the specified type of v-belt should be selected and the elasticity of each group of v-belts should be consistent. Do not allow the old and new mixed or reduce the number of uses, otherwise it will make the old and new V-belt force. Uneven, or even make the old V-belt does not work, affecting the power transmission and shortening the service life of V-belt.

Strictly prevent pollution In the process of use, strictly prevent the V-belt from being contaminated with mud, water and oil, and avoid contact with acid, alkali and other corrosive substances to prevent the V-belt from slipping, corrosion and early damage.

Daily maintenance operators and users in the normal driving should master the correct operating principles, and according to the technical requirements of the manual, try to avoid sudden start and sudden braking; also to prevent frequent overload work, if not used for a long time, to remove the V-Belt storage alone.


  • wechat

    86 189 1525 5330: 86 189 1525 5330

Converse conosco